Regular Hinge

Hinge cup drilled in the back of the door is 35mm (1-3/8″) in diameter.

Door opening angle is 105 degrees. Hinge allows adjustments after installation

This hinge may be used to retrofit existing cabinets. Simply detach your existing hinges from thecabinets, replace the hinges using the existing screws.

ADVISORY:

This hinge requires that the cup drilled in the back of your door is at least 13mm (1/2″ deep). Top hinges required a 12.5mm cup depth. We recommend that you measure the cup depth on your doors before ordering. Many cabinet makers used a 13mm cup depth even though the requirement was only 12.5mm so yours may actually already be drilled to 13mm.

• Each hinge uses FOUR each #6 flat head screws (not included but offered for purchase during checkout).
• Hinge is made from steel and nickel plated.